
Thunder Laser successfull…
Release Time:2019/07/08Browsing Times:490
Proper care and routine maintenance of the machine will ensure optimal performance over a long service life. DAILY CHECK LIST ☑ Focus lens WEEKLY CHECK LIST ☑ Reflector ☑ Laser...
Release Time:2019/07/08Browsing Times:473
The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anything ...
Release Time:2019/07/08Browsing Times:501
Operation manual for Thunder laser machine To be safe, never ever run the laser system unattended. According to international standard,“O”means close;“I”means open for the rocker switch below. Tu...
Release Time:2019/07/08Browsing Times:406
Contents 1 Function of the Buttons……………………………………2 2 The main interface……………………………………4 2.1 Speed Key……………………………………5 2.2 Max Power Keys……………………………………5 2.3 Set the Layer Parameters……………………………………5 2.4 ...
Release Time:2019/06/01Browsing Times:705
Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, please open the lower...
Release Time:2019/06/01Browsing Times:417
Here are the reasons: ● The starting point is set to absolute coordinate in software. Locate on the bottom left corner, the option of “Position” please select to Current position. ● Ori...
Release Time:2019/06/01Browsing Times:429
Firstly, turn off the whole machine power. Remove Old Part: Open the lower right hand door panel, find the main controller board, like below. Unplug all connectors on the controller board, then rem...
Release Time:2019/06/01Browsing Times:478
Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Keep the water level i...