สร้างความแตกต่างให้กับลูกค้าของเรา
02-136-1770

ธันเดอร์เลเซอร์ ประเทศไทย

troubleshooting troubleshooting

Location:Home >troubleshooting
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • How to calibrate the working table to level.

    How to calibrate the working table to level.

    Release Time:2016/12/07Browsing Times:812

    There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of th...

  • Some point of the same piece of materials can not be cut through, why

    Some point of the same piece of materials can not be cut through, why

    Release Time:2016/12/06Browsing Times:767

    Some point of the same piece of materials cannot be cut through, why? This problem is mainly caused by following three reasons: 1. The cutting material is bent (not flat) or uneven density. 2. The ...

  • Why the laser has no laser beam?

    Why the laser has no laser beam?

    Release Time:2016/11/29Browsing Times:832

    Following reasons cause the failure of laser working (has no laser beam) 1. Cooling system problem (includes water chiller) 2. Laser power supply (optical coupled isolator) or Laser tube 3. Wiring ...

  • Why the Y axis cannot work suddenly?

    Why the Y axis cannot work suddenly?

    Release Time:2016/11/28Browsing Times:937

    1. Please check if the rotary switch is turned on,like below: PS: Turning to “O” off means all is normal. If it is “-“, please turn off to “O” and press the reset on control...

  • Why does the cutting and engraving graphics reverse (mirror)

    Why does the cutting and engraving graphics reverse (mirror)

    Release Time:2016/11/23Browsing Times:1092

    This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. Make...

  • Why does the graphic size that imported to RDWorks different from its original size

    Why does the graphic size that imported to RDWorks different from its original size

    Release Time:2016/11/21Browsing Times:973

    If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is set as “m...

  • How to run several laser machines with one PC

    How to run several laser machines with one PC

    Release Time:2016/11/17Browsing Times:583

    If there are several USB interfaces with your PC, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the fi...

  • How to install the CorelDraw plugin for RDWorks

    How to install the CorelDraw plugin for RDWorks

    Release Time:2016/11/11Browsing Times:1375

    1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (b...